7.1. Determine Wedges to Use

Based on Table 2 and the transom angle determined in Section 6, compile the Transom Plate, Actuator Plate, Wedge Pack Hardware kit and appropriate wedges for port and starboard. It is possible that the hull has different angles for each location.

  1. Stack the proper number of Wedge Plates on top of the Transom Plate using the tabs and grooves on the Wedge Plates shown below to keep them in the correct orientation. There are matching tabs on the Transom Plate to assist with alignment.
  2. Place the Actuator Plate on top to complete the Wedge Pack Assembly.
Figure 23 – Locking Tabs and Groves of Wedge Plates.