5.2 Supplies Required for Installation

(Not Supplied With the Seakeeper)

Item	Description	Qty	Installation Manual Reference Section	Other Reference	System
1	Soundproofing Considerations		Selection of Installation Location		Mechanical
2	Spreader bar for lifting the Seakeeper	1	Transport and Unpacking		Mechanical
3	Seakeeper 2 Fixture Kit	1	Bolt-In Installation	P/N 90473	Mechanical
4	Hose clamps for seawater plumbing to ¾ in. (19 mm) hose barb (2 per hose barb)	4	Connecting Seawater to Heat Exchanger	Dwg 90490	Cooling
5	3/4 in. (19 mm) ID Hose	AR	Connecting Seawater to Heat Exchanger	Dwg 90490	Cooling
6	Seacock Valve	1	Connecting Seawater to Heat Exchanger	Dwg 90490	Cooling
7	Seawater Strainer (included with Seakeeper Seawater Pump (P/N 30331))	1	Connecting Seawater to Heat Exchanger	Dwg 90490	Cooling
8	Through-Hull Fittings (1 high speed pick up and 1 overboard discharge)	2	Connecting Seawater to Heat Exchanger	Dwg 90490	Cooling
9	M6 terminal lug for grounding Seakeeper at rear brace	1	Electrical Equipment Ground Connections	Dwg 90470	Electrical
10	Cable, 4 AWG, for grounding Seakeeper at foundation to vessel ground (used with item 5)	AR	Electrical Equipment Ground Connections	Dwg 90470	Electrical
11	Seawater pump, 12 VDC, 15A max	1	Electrical Equipment DC Pump Power	Dwg 90470	Electrical
12	100 A Circuit breaker for Conductor 1	1	Electrical Equipment High Current Power Input	Dwg 90470	Electrical
13	15 A Circuit breaker for Low Current Power and DC Seawater Pump	2	Electrical Equipment Low Current Power Input	Dwg 90470	Electrical
14	Battery Isolator Switch	1	Electrical Equipment Power Connections	Dwg 90470	Electrical
15	Marine Sealant	AR	Bolt-In Installation	DWG 90487	Mechanical
16	Nickel-based Anti-Seize	AR	Bolt-In Installation	DWG 90487	Mechanical

AR = As Required
Dwg = Drawing

Previous

7.0 Revision History

Next

5.3 Tools Required for Installation