New Build

Buying a new boat?

See our list of builders offering Seakeeper on their boats.

Search Builders
Refits

Have an existing boat?

Find a Dealer See Completed Installations
Explore Refit Process Explore Financing Options

Seakeeper 35 / 30HD Installation Manual (90268-7)

Manuals Home Contact Support Print Manual

Seakeeper 35 / 30HD Installation Manual (90268-7)

Installation of Seakeeper

  1. Locate and position 4 isolation gaskets onto foundation beams (for metal to metal contacts only).
    NOTE: A VERY SMALL AMOUNT OF SEALANT MAY BE APPLIED TO THE GASKET TO KEEP WATER FROM WICKING INTO THE JOINT.
  2. Lower Seakeeper into position onto foundation beams and align over drilled holes.
  3. Install Seakeeper supplied M16 fasteners as shown in figure below – apply a moderate coat of nickel based anti-seize compound to the threads of each bolt prior to installation and a small amount of sealant to the washer faces.
  4. Torque all fasteners to 100 ft-lbs (136 N-m).
  5. Proceed to electrical and cooling portion of the installation.
View All Pages