Seakeeper 35 / 30HD Installation Manual (90268-7)
Required Supplies Needed for Seakeeper Installation
Required Supplies Needed for Seakeeper Installation
(Not Supplied With the Seakeeper)
Item | Description | Qty | Installation Manual Reference Section | Other Reference | System |
---|---|---|---|---|---|
1 | Adhesive and cleaning supplies for bonding to hull | Mechanical Installation | Mechanical | ||
2 | Soundproofing Considerations | Selection of Installation Location | Mechanical | ||
3 | Spreader bar for lifting Seakeeper | Transport and Unpacking | Mechanical | ||
4 | Hose clamps for seawater plumbing to 1 in. (25.4 mm) hose barb (2 per hose barb) | 4 | Connecting Seawater to Heat Exchanger | Cooling | |
5 | Circuit Breaker, AC, 2-Pole, 20 A | 1 | Electrical Equipment Power Connections | Dwg 90288 | Electrical |
6 | Circuit Breaker, DC, 1-Pole, 10 A | 1 | Electrical Equipment Power Connections | Dwg 90288 | Electrical |
7 | M6 terminal lug for grounding Seakeeper at rear of foundation | 1 | Electrical Equipment Ground Connections | Electrical | |
8 | Cable, 10 AWG, for grounding Seakeeper at rear brace to vessel ground (used with item 5) | AR | Electrical Equipment Ground Connections | Dwg 90288 | Electrical |
9 | Seawater pump, 230 VAC | 1 | Electrical Equipment Power Connections | Electrical | |
10 | Relay for seawater pump control (Not required if using 230 VAC pump) | 1 | Electrical Equipment Power Connections | Electrical |
AR = As Required
Dwg = Drawing
List of Common Tools That May Be Required for Installation
Item | Description | Use |
---|---|---|
1 | Wire cutter | DC Power, AC Power cables |
2 | Wire stripper | DC Power, AC Power cables |
3 | Phillips head screwdriver | Cover Panels |
4 | 13 mm Socket Wrench | Cover Panels |
5 | 3 mm hex key | Gimbal sensor mount plate |
6 | 2.5 mm hex key | Gimbal angle sensor |
7 | ΒΌ in. nutdriver | Hose clamps |
8 | Terminal or quick disconnect crimper | Power cables |
9 | Utility knife | Scoring cable jackets |
10 | 10 mm Socket Wrench | Ground Stud |