2.5.6 Installation of Seakeeper

Rig Seakeeper for lifting and lower it into position onto top surface of four saddles.
Adjust position of the Seakeeper until alignment is achieved for the 32 fasteners that will attach the Seakeeper foundation frame to saddles.
Install Seakeeper supplied M16 fasteners as shown in figure below – apply a moderate coat of nickel based anti-seize compound to the threads of each bolt prior to installation.
Torque all fasteners to 100 ft-lbs (136 N-m).
Apply a small bead of sealant (silicone or caulk) around the perimeter of each isolation mount where it rests on the saddle. This will prevent water from wicking between the parts and setting up corrosion.
Proceed to electrical and cooling portion of the installation.

2.5.5 Bonding Saddles to Hull

3.1 Electrical Introduction