Second Operator Station Connection

This section explains how to connect the 2^nd Operator Station Kit.

Reference Documents & Drawings

• 90467 – Helm Display 2^nd Operator Station Kit
• 90539 – Seakeeper 16/18 Cable Block Diagram (includes detail of 2^nd Operator Station)

Determine Location of 2^nd Operator Station

1. The desired location of the 2^nd Operator Station must be determined with respect to the 1^st Operator Station and the vessel arrangement.
2. Typical locations include:
   1. Flybridge
   2. Engine room

Determine Cabling Arrangement

1. Figure 9 below shows the entire serial communications link for 2 Operator Stations. The Terminator must be installed on the Tee Adapter farthest from the Seakeeper.

2. The Operator Station nearest the Seakeeper should be connected to Cable 3.

Route 2^nd Operator Station Cable

1. A second CAN Cable Assembly (P/N 30243), also a 25 m shielded cable, and the largest connector is a molded plug with maximum outer diameter of .58 in. (14.8 mm).
2. The additional CAN Cable Assembly must be routed in the vessel from the 1^st Operator Station (female end) to the 2^nd (male end) Operator Station.

Install 2^nd Operator Station Equipment

1. The 2^nd Operator Station equipment is installed at the determined location using instructions found in Section: Electrical Equipment Mounting.

Connect 2^nd Operator Station Equipment

1. The 2^nd Operator Station equipment is connected in accordance with Drawing No. 90539 – Seakeeper 16/18 Cable Block Diagram.