5.2 Required Supplies for Seakeeper Installation

(Not Supplied With the Seakeeper)

Item	Description	Qty	Installation Manual Reference Section	Other Reference	System
1	Adhesive and cleaning supplies for bonding to hull		Mechanical Installation		Mechanical
2	Soundproofing Considerations		Selection of Installation Location		Mechanical
3	Spreader bar for lifting Seakeeper		Transport and Unpacking	P/N 80029	Mechanical
4	Circuit Breaker, AC, 2-Pole, 20 A	1	Electrical Equipment Power Connections	Dwg 90310	Electrical
5	Circuit Breaker, DC, 1-Pole, 10 A	1	Electrical Equipment Power Connections	Dwg 90310	Electrical
6	M6 terminal lug for grounding Seakeeper at rear brace	1	Electrical Equipment Ground Connections		Electrical
7	Cable, 10 AWG, for grounding Seakeeper at rear brace to vessel ground	AR	Electrical Equipment Ground Connections	Dwg 90310	Electrical
8	Sili-Thane 803 Marine Sealant (or equivalent)	AR	Bolt-In Installation, Installation of Seakeeper and Saddle Installation, Installation of Seakeeper		Mechanical
9	Nickel-based Anti-Seize	AR	Bolt-In Installation, Installation of Seakeeper and Saddle Installation, Installation of Seakeeper		Mechanical
10	Seawater Pump, 24 VAC	1	Electrical Equipment Power Connections	Dwg 90320	Electrical
11	Relay for seawater pump control (Not required if using 230 VAC pump)	1	Electrical Equipment Power Connections		Electrical
12	¾ in. (19 mm) ID seawater hose	AR	Cooling Installation	Dwg 90320	Cooling
13	Hose clamps for seawater plumbing to ¾ in. (19 mm) hose barb (2 per hose barb)	4	Cooling Installation	Dwg 90320	Cooling
14	Through-hull fittings (1 high-speed pick-up / 1 overboard discharge)	2	Cooling Installation	Dwg 90320	Cooling
15	Seawater strainer	1	Cooling Installation	Dwg 90320	Cooling
16	Seacock valve	1	Cooling Installation	Dwg 90320	Cooling
17	Flow restriction valve (optional)	1	Cooling Installation	Dwg 90320	Cooling

AR = As Required
Dwg = Drawing

Previous

5.1 Installation Requirements Introduction

Next

6.1 Installation and Start Up Introduction