Home
  • Who We Are
  • Join Our Team
  • Seakeeper
  • Products

      Find your system by boat size

      View All Products

      For boats up to 26 ft

      Seakeeper Ride 450

      For boats 27-30 ft

      Seakeeper Ride 525

      For boats 31-36 ft

      Seakeeper Ride 600

      For boats 37-42 ft

      Seakeeper Ride 750

      For boats 43 - 55 ft

      Seakeeper Ride 750

  • How to Buy
    • How to Buy
    • Find a New Boat with Ride
    • Refit Your Existing Boat
    • Find a Dealer
    • Shop Ride
    • Browse Ride Models
    • Start Your Refit
    • See Completed Refits
    • More from Ride
    • Ride Support
    • Become a Dealer
    • Schedule a Demo
  • Performance
  • Explore
    • How it Works
    • Schedule a Demo
    • FAQs
  • Support
  • Contact
    • Contact Us
    • Find a Dealer
Skip to content

Electrical Installation Manual

Manuals Home Contact Support Print Manual

Electrical Installation Manual

  • 1. Introduction
  • 2. Safety Notices
  • 3. Drawings
  • 4. Tools and Equipment Needed
  • 5. Inventory Parts
  • 6. Component Details and Installation Location
    • Component Details and Installation Location Introduction
    • 6.1. Software Module
    • 6.2. Distribution Module
    • 6.3. Keypad (Optional)
    • 6.4. Seakeeper Ride Proprietary CAN Bus
    • 6.5. 25 Amp Circuit Breaker or Fuse
  • 7. Mounting
    • 7.1. Software Module Mounting
    • 7.2. Distribution Module Mounting
    • 7.3. Keypad Mounting (Optional)
  • 8. Wiring and Terminating Cables
    • Wiring Introduction
    • 8.1. Seakeeper Ride Proprietary CAN Bus
    • 8.2. Software Module Wiring
    • 8.3. Distribution Module Wiring
    • 8.4. Keypad Wiring (Optional)
  • 9. NMEA Notes

8.4. Keypad Wiring (Optional)

Connect a NMEA 2000 cable to the Keypad and Seakeeper Ride CAN Bus Tee (E in Figure 11) using the 3 m (6.6 ft) cable supplied.

You have now completed the electrical installation of the Seakeeper Ride system. Follow the instructions in the Seakeeper Ride Commission Instructions for the first start and calibration of the system.

Previous

8.3. Distribution Module Wiring

View All Pages

Next

9. NMEA Notes