8.2. Software Module Wiring

Seakeeper Ride Proprietary CAN Bus Cable

Connect a NMEA 2000 cable between the Software Module attachment point labeled “SK,” and the Seakeeper CAN Bus Tee (F in Figure 11). The 3.3 ft (1 m) cable supplied is recommended.

On the male end of this CAN Bus Tee, attach a Female Terminator (G in Figure 11).

Seakeeper Proprietary CAN Bus negative wire will need Clean Ground because, it cannot go through the engine manufacturers wiring harness or it will lose power when engine is started.

NMEA 2000 Network

From the side of the Software Module labeled “NMEA,” attach a NMEA 2000 cable to the boat’s NMEA 2000 Network Backbone. The 19.7 ft (6 m) cable supplied is recommended.

This may require a new Tee added to the backbone (not included).

Be sure to follow NMEA Backbone protocol and observe Terminator and Tee requirements.

Ethernet Connection

From the port side of the Software Module labeled “Ethernet,” attach the Ethernet Adapter Cable that suits the boat’s Multifunction Display. This cable must be purchased separately from Seakeeper.