6.2 Required Supplies Needed for Seakeeper Installation

6.2.1 (Not Supplied With the Seakeeper)

Item	Description	Qty	Installation Manual Reference Section	Other Reference	System
1	Adhesive and cleaning supplies for bonding to hull		Mechanical Installation		Mechanical
2	Soundproofing Considerations		Selection of Installation Location		Mechanical
3	Spreader bar for lifting Seakeeper		Transport and Unpacking		Mechanical
4	Hose clamps for seawater plumbing to ¾ in. (19 mm) hose barb (2 per hose barb)	4	Connecting Seawater to Heat Exchanger		Cooling
5	Circuit Breaker, AC, 2-Pole, (30 A to be used with 110-120 VAC, OR Nominal (± 10%), 20 A to be used with 208-230 VAC Nominal (± 10%))	1	Electrical Equipment Power Connections	Dwg 90396	Electrical
6	Circuit Breaker, DC, 1-Pole, 15 A	2	Electrical Equipment Power Connections	Dwg 90396	Electrical
7	M6 terminal lug for grounding Seakeeper at rear brace	1	Electrical Equipment Ground Connections		Electrical
8	Cable, 10 AWG, for grounding Seakeeper at rear brace to vessel ground	AR	Electrical Equipment Power Connections	Dwg 90396	Electrical
9	Seawater pump, 12 VDC	1	Electrical Equipment Ground Connections		Electrical
10	Relay for seawater pump control (Not required if using Seakeeper output 12 VDC pump)	1	Electrical Equipment Power Connections		Electrical

AR = As Required
Dwg = Drawing

6.2.2 List of Common Tools That May Be Required for Installation

Item	Description	Use
1	Wire cutter	DC Power, AC Power cables
2	Wire stripper	DC Power, AC Power cables
3	13 mm Socket Wrench	Cover Panels
4	Phillips head screwdriver, 5/64 inch	Cover Panels
5	Slot screwdriver, 5/64 inch	Field assembly connectors
6	¼ in. nut driver	Hose clamps
7	Terminal or quick disconnect crimper	Power cables
8	Utility knife	Scoring cable jackets
9	10 mm Socket Wrench	Ground Stud

Previous

6.1 Installation Checklist