5.2 Required Supplies for Seakeeper Installation

Required Supplies Needed for Seakeeper Installation
(Not Supplied With the Seakeeper)

Item	Description	Qty	Installation Manual Reference Section	Other Reference	System
1	Adhesive and cleaning supplies (for bond-in installation) (Total area of adhesive is 1,300 in.² (8,387 cm²))	AR	2.5 Mechanical Installation	Adhesive manufacturer’s instructions and Dwg 90878	Mechanical
2	Soundproofing Considerations	AR	2.2 Selection of Installation Location		Mechanical
3	Spreader bar for lifting Seakeeper	1	1.2 Transport and Unpacking	P/N 80029	Mechanical
4	Hose clamps for seawater plumbing to 1 in. (25.4 mm) hose barb (2 per hose barb)	4	4.3 Connecting Seawater to Heat Exchanger		Cooling
5	3/4″ to 1″ Hose Adapter	1	4.3 Connecting Seawater to Heat Exchanger		Cooling
6	Circuit Breaker, AC, 2-Pole, 20 A	1	3.2 Electrical Equipment Power Connections	Dwg 90710	Electrical
7	Circuit Breaker, DC, 1-Pole, 15 A for control power	1	3.2 Electrical Equipment Power Connections	Dwg 90710	Electrical
8	Circuit Breaker, DC, 1-Pole, 20 A for seawater pump	1	3.2 Electrical Equipment Power Connections	Dwg 90710	Electrical
9	M6 terminal lug for grounding Seakeeper at rear of foundation	1	3.3 Electrical Equipment Ground Connections		Electrical
10	Cable, 10 AWG, for grounding Seakeeper at rear brace to vessel ground	AR	3.3 Electrical Equipment Ground Connections	Dwg 90710	Electrical
11	Seawater pump, 24 VDC	1	3.2 Electrical Equipment Power Connections	P/N 30490 available	Electrical
12	Relay for seawater pump control (Optional)	1	3.2 Electrical Equipment Power Connections		Electrical
13	Sili-Thane 803 Sealant (or equivalent)	AR	2.4.3 Mechanical Installation 2.5.3 Mechanical Installation		Mechanical
14	Nickel-based Anti-Seize	AR	2.4.3 Mechanical Installation 2.5.3 Mechanical Installation		Mechanical

AR = As Required
Dwg = Drawing

Previous

5.1 Installation Requirements Introduction

Next

5.3 Tools Required for Installation