Seakeeper 40 Installation Manual (90715-2) 40-234-0043 to Current
5.3 Tools Required for Installation
List of Common Tools That May Be Required for Installation
| Item | Description | Use |
|---|---|---|
| 1 | Wire cutter | DC Power, AC Power cables |
| 2 | Wire stripper | DC Power, AC Power cables |
| 3 | Phillips head screwdriver | Cover Panels |
| 4 | 13 mm Socket Wrench | Cover Panels |
| 5 | 3 mm hex key | Gimbal sensor mount plate |
| 6 | 2.5 mm hex key | Gimbal angle sensor |
| 7 | ΒΌ in. nut driver/flat tip screwdriver | Hose clamps |
| 8 | Terminal or quick disconnect crimper | Power cables |
| 9 | Utility knife | Scoring cable jackets |
| 10 | 10 mm Socket Wrench | Ground stud & panels |
| 11 | Hoist, Forklift, or Crane | Unpacking and lifting Seakeeper into position |
| 12 | Drill/Drill Press | Bolt hole penetrations |
| 13 | Threaded Insert Installation Kit (Blind Hole Installation only) | Tap and install threaded inserts for M16-2.0. 1-inch length |
| 14 | 1/2 in. Drive Torque Wrench | Foundation fastener torqueing |
| 15 | 24 mm Socket, 1/2 in. drive | Foundation mounting screws |
| 16 | Fish tape | Cable pulls |
| 17 | Hole Saw | Through-hull fittings |