6.3 Start Up Checklist

(Reference Installation Manual Section: Start Up & Operation Manual Section: System Operation)

• Remove lifting eyes, install sealing fasteners in lifting holes, and install cover panels
• Check polarity of 24 VDC power per Section: Electrical Equipment Power Connections – DC Power and Seawater Pump Connection Instructions.
• Turn on 24 VDC circuit breakers for control power and DC Seawater Pump
• Turn on 230 VAC circuit breaker
• Verify display works and no ALARMS are present
  
  • If display does not work, turn off both circuit breakers immediately.
• Follow instructions in Operations Manual Section: Start Up Instructions to turn on the Seakeeper
• Verify that no ALARMS are present
• Follow instructions in Section: Start Up Instructions to turn off the Seakeeper
• AC & DC power and seawater pump may be turned off after the Seakeeper is turned off by placing the Seakeeper in LOCK mode and turning the Seakeeper off.
• Seakeeper 40 takes 4+ hours to coast down to 0 RPM from full speed