Seakeeper 4 / 4.5 Installation Manual (90762-1)
3.2.2 Seakeeper 4.5 Motor Power Connection
AC Input Power Source Requirements
- Either of two AC input voltages are acceptable:
- 110 – 120 VAC (nominal) (+/- 10%), 1 Phase, 50/60 Hz, 30 A
- 208 – 230 VAC (nominal) (+/- 10%), 1 Phase, 50/60 Hz, 20 A
- A separate circuit breaker should be used for each Seakeeper Drive Box in multiple Seakeeper installations.
AC Power Input Connection Instructions
AC Input Cable (3 X 10 AWG or 3X 0.6mm2 CSA), 10 ft (3 m) length, Seakeeper supplied pre-installed.
- Locate AC Input Cable for AC power input to the Drive Box.
ADD IMAGE IF DESIRED (SHOWING AC CABLE OUT OF SK 4.5)

- Connect AC wires in to a 230 V, 20 A (or 110 V, 30 A), double-pole Circuit Breaker at an AC power distribution panel.