Seakeeper 4 / 4.5 Installation Manual (90762-1)
3.1 Electrical Installation Introduction
This section for electrical installation explains how to mount the electrical equipment and connect the electrical cables.
Reference Documents:
- 90737 – Seakeeper 4.5 Hardware Scope of Supply
- 90696 – Seakeeper 4.5 Cable Block Diagram
- 90699 – Seakeeper 4 Cable Block Diagram
- TB-90191 – Seawater Cooling Pump Recommendations
- TB-90621 – Seakeeper Battery Sizing Recommendations
- TB-90640 – ConnectBox Connection Requirements
- Seakeeper MFD Compatibility Technical Bulletins:
- Optional 5″ Touch Display
Because of the different motor power requirements between Seakeeper 4 and Seakeeper 4.5, the Motor Power Connections are separated into independent subsections (Sect. 3.2.1 and 3.2.2). The Control Power, Seawater Power, Ground, and ConnectBox connection requirements (Sect. 3.3 through 3.6) are the same for both models.
The following images show the electrical equipment included with the Seakeeper 4 and 4.5 Hardware Scope of Supply (Drawing No. 90737):
16.4 ft (5 m), P/N 20248
16.4 ft (5 m), P/N 30327
16.4 ft (5 m), P/N 20334
19.7 ft (6 m), P/N 30332
32.8 ft (10 m), P/N 30330
