5.3 Tools Required for Installation

Table 2 outlines the tools and equipment required for the Seakeeper 3 installation:

Item	Description	Use
1	Hoist, Forklift, or Crane	Unpacking and lifting Seakeeper 3 into position
2	Transfer Punch Kit	Locate foundation hole penetrations
3	Drill / Drill Press	Bolt hole penetrations
4	Threaded Insert Installation Kit	Tap and install threaded inserts (M14-2 X 1.5)
5	1/2″ Drive Torque Wrench	Foundation Bolts (155 ft-lbs/210 Nm)
6	12 – 18″ Extension, 1/2″ Drive	Foundation Bolts
7	24mm Socket, 1/2″ Drive	Foundation Bolts
8	Utility Knife	Scoring Cable Jackets
9	Wire cutter	DC Power cables
10	Wire stripper	DC Power cables
11	Greenlee K05-Synchro Crimp Tool or equivalent	12 VDC High-Current Input Cables, 2AWG Ground Cable, 4 AWG
12	Heat Gun	For cables 1, 2, and 6 heat shrink
13	¼ in. (7mm) Nut Driver / Flat Head Screwdriver	Hose clamps
14	Fish Tape	Cable Pulls
15	Hole Saw	Thru-hull fittings

NOTE: Additional tools may be required for the installation of customer supplied components.

5.2 Required Supplies for Seakeeper Installation

6.1 Installation and Start Up Introduction