6.3 Start Up Checklist

Startup Checklist (reference Installation Manual Section 4 & Operation Manual Sec.  2)

CHECK	ACTION
	Remove lifting eye-bolts and install cover panels
	Turn on Seakeeper, 24 VDC circuit breaker
	Turn on Seawater pump, 24 VDC circuit breaker
	Turn on 230 VAC circuit breaker
	Verify MFD app / 5″ touch display works and no ALARMS are present
	Follow instructions in Operation Manual to turn on the Seakeeper
	Verify seawater pump turns on while the Seakeeper is turned ON (It will run only as needed)
	Verify that no ALARMS are present
	Follow instruction in Section 4.1 of Installation Manual to turn off the Seakeeper
	The Seakeeper is powered off by switching off the AC & DC power and seawater pump. The Seakeeper will automatically be in LOCK mode once the system is turned off
	Seakeeper 18 takes 4.5+ hours to coast down to 0 RPM from full speed