Seakeeper 18 Installation Manual (90672-2); S/N 18-234-2475 to Current
5.0 Installation Requirements
5.1 Installation Requirements Introduction
The Installation Requirements section outlines the components and tools needed for the Seakeeper 18 Installation that are not included within the scope of supply.
5.2 Required Supplies for Seakeeper Installation
Required supplies needed for Seakeeper installation
(Not supplied with the Seakeeper)
Item | Description | Qty | Section | Other Reference | System |
1 | Adhesive and cleaning supplies for bonding to hull | Mechanical Installation Bond-In Installation | Mechanical | ||
2 | Soundproofing considerations | Selection of Installation Location | Mechanical | ||
3 | Spreader bar for lifting Seakeeper | 1 | Transport and Unpacking | Mechanical | |
4 | Hose clamps for seawater plumbing to 3/4 in. (19 mm) hose barb (2 per hose) | 4 | Connecting Seawater to Heat Exchanger | Cooling | |
5 | Circuit breaker, AC, 2-pole, 30 A | 1 | Electrical Equipment Power Connections | Dwg 90679 | Electrical |
6 | Circuit breaker, DC, 1-pole, 10 A | 1 | Electrical Equipment Power Connections | Dwg 90679 | Electrical |
7 | M6 terminal lug for grounding Seakeeper at rear brace | 1 | Electrical Equipment Ground Connections | Electrical | |
8 | Cable, 10 AWG, for grounding Seakeeper at rear brace to vessel ground | AR | Electrical Equipment Ground Connections | Dwg 90679 | Electrical |
9 | Seawater pump, 24 VDC (Optional Seakeeper supplied) | 1 | Electrical Equipment Power Connections | Dwg 30322 | Electrical |
10 | Circuit breaker, DC, 1-pole, Current rated for SW pump | 1 | Electrical Equipment Power Connections | Dwg 90679 | Electrical |
12 | Sili-Thane 803 Sealant (or equivalent) | AR | Mechanical Installation | Mechanical | |
13 | Nickel-based Anti-seize | AR | Mechanical Installation | Mechanical |
Dwg = Drawing