5. Software Module Replacement

If the Software Module is damaged or needs to be replaced for any other reason, refer to the following steps:

1. Turn off power to the boat.
2. Use tape and a writing utensil or some other method to label the three (3) cables connected to the Software Module: NMEA, SK, and Ethernet.

3. Disconnect the three (3) cables from the Software Module.
4. Remove the four (4) No. 10 x 1 in. mounting screws.

5. Remove the old Software Module and hold the new Software Module in place.
6. Reinsert and tighten the four (4) No. 10 x 1 in. mounting screws.
7. Reattach the three (3) cables to the Software Module according to the labels.
8. Power the boat back on, and follow the instructions to calibrate the new Software Module in the Seakeeper Ride Commissioning Instructions.