4.2 24 VDC Failure

If the 24 VDC is disconnected during operation, the display will be blank, flywheel speed will decrease, and the brake will be locked (no precession).

• Verify the boat’s circuit breaker supplying 24 VDC has not tripped and the AC breaker is On.
• When 24 VDC is restored, the display will power up, the Splash Screen will appear, and then the Home Screen will appear. Operation may not be available for up to 15 minutes as sensors reset
• Press Power On/Off button . The progress bar will appear and indicate flywheel speed. When the flywheel is at minimum operating speed, the Stabilize button will appear so stabilization can be turned on. This may take up to 30 minutes, depending on the speed of the flywheel when the 24 VDC is turned back on.