New Build

Buying a new boat?

See our list of builders offering Seakeeper on their boats.

Search Builders
Refits

Have an existing boat?

Find a Dealer See Completed Installations Remanufactured Products Explore Financing
Explore Refit Process

Seakeeper 5 Operation Manual (90960-1)

Manuals Home Contact Support Print Manual

Seakeeper 5 Operation Manual (90960-1)

3.3.2 Stabilization

Boat operators are advised that the Seakeeper’s sole function is to dampen a boat’s cyclic roll motions. The Seakeeper is not, and is not intended to be, a substitute for adequate hull stability about the pitch, roll, and yaw axes, and the Seakeeper is not designed to prevent any instability due to improper boat operation, including, without limitation, any aggressive maneuvers at high speed. During aggressive maneuvers at high speed, the Seakeeper outputs a constant pitch moment, which can create a small bow-down or bow-up trim change.

Improper boat operation, including, without limitation, aggressive maneuvers at high speed, can result in the boat becoming unstable. If you intend to operate the boat in such a manner, you should lock the Seakeeper in the vertical position before operating the boat in that manner. This is easily accomplished by turning the boat to starboard at slow speed in the Stabilize mode. After turning to starboard for 5 seconds, turn the Stabilize mode off while continuing to turn, and then go to the Service Page on the display and confirm the Gyro Angle is within +10 degrees of 0 degrees.

To stabilize the vessel after the Seakeeper is On and the flywheel is above the minimum stabilization RPM:

  1. Press the Stabilize button on the MFD application or at the ConnectBox. The button will turn blue, indicating that the Seakeeper is stabilizing the roll motion..

If it is necessary to shut off power to the flywheel motor and slow the flywheel for any reason, press the Seakeeper On/Off button; the button will turn grey, and the Stabilize button will disappear, indicating the command has been accepted. It takes approximately 4+ hours for the speed to slow down to 0 RPM.

If it is necessary to stop Seakeeper motion for any reason, press the Stabilize button. The Stabilize button will turn grey, indicating that the Seakeeper is locked. Never attempt to work on the Seakeeper until the flywheel has stopped spinning. In the event that the brake system has automatically locked the Seakeeper due to an alarm or failure, no attempt should be made to bypass the alarm or automatic lock.

View All Pages