Software Module to PC Connection Instructions

• On the Software Module, set dipswitch ‘switch 1’ to ‘ON’, switch 1 is the one furthest away from the USB connector.

• Using a Seakeeper Furuno connection cable (Part #20506SP).
• Plug the M12 4 pin end to the Software Module Ethernet Port.
• Connect the RJ45 end to your computer or laptop ethernet port.
• Power up the Software Module.
• Powering on Software Module needs to be done after setting the switch to the correct position.
• Go to internet browser such as chrome/edge and type in 172.16.100.1 into the address bar

• From here you can control your Seakeeper Ride equipment via your internet browser, use your mouse to click the associated buttons.