Seakeeper Ride | Torque Specifications
Torque Specifications
Updated 10/11/2022
When installing or reinstalling any component of Seakeeper Ride, make sure to apply thread locking sealant activator/primer and thread locking sealant to bolts. Use a torque wrench to tighten bolts to the correct specification shown below. Bolts or screws not listed below do not have a torque specification and should be tightened snug to prevent movement but not overtightened. Do not tighten bolts in a straight or circular path, one right after another. Instead, tighten in an alternating or ‘X’ pattern.
| Location | Hardware Used | Torque (in-lbs) | Torque (N-M) |
| Positioning Screws | Screw | 20 | 2.3 |
| Wedge Pack Assembly | M8 | 75 | 8.5 |
| Seal Plate to Actuator Plate | M6 | 50 | 5.7 |
| Arms to Actuator | M10 | 300 (25 ft-lbs) | 33.9 |
| Anodes to Arms | M4 | 20 | 2.3 |
| Blades to Arms | M8 | 80 | 9 |