Preparing the Wedge Pack Introduction

This portion of the installation will require the Wedge Pack hardware kit illustrated in Section 4. 

To begin the Transom Plate must be assembled. This requires selecting the correct length bolts as indicated by the transom angle table above. 

1. Place a Cylindrical Washer for Hex Head on each bolt, with the flat side on the head of the bolt. 
2. Install the bottom three (3) M8 bolts selected based upon the total Wedge Plates in use. See Table 2 to determine if the 35 mm or 40 mm bolts must be used. (Quantity four [4] bolts for 525 Controllers and five [5] bolts for 750 Controllers.) 
3. Install the top two (2) M8 bolts selected based upon the total Wedge Plates in use. See Table 3 to determine if the 55 mm or 75 mm bolts must be used. (Two [2] top bolts and four [4] bottom bolts for 525 Controllers. Four top bolts and five [5] bottom bolts for 750 Controllers.)
4. At this point, the bolts must be inserted into the Transom Plate with Cylindrical Washer for Hex Head cylinder in each of the five (5) locations. (Quantity six [6] bolts for 525 Controllers and nine [9] bolts for 750 Controllers.)
5. Cover the bolt head with the supplied self adhesive backed plastic caps. The caps will prevent adhesive leak by around the bolts and allow for tuning the equipment by adding or removing wedges once installed and adhesive has cured.