Torque Specifications (750, 750 Quad)
Torque Specifications Ride 750
Updated 10/23/2024
When installing or reinstalling any component of Seakeeper Ride, make sure to apply thread locker to bolts. Use a torque wrench to tighten bolts to the correct specification shown below. Be sure to verify torque is achieved with 2 rounds of torque per fastener. Bolts or screws not listed below do not have a torque specification and should be tightened snug to prevent movement but not overtightened. Do not tighten bolts in a straight or circular path, one right after another. Instead, tighten in an alternating or ‘X’ pattern.
| Location | Hardware Used | Torque (in-lbs) | Torque (N-M) |
| Positioning Screws | Screw | 20 | 2.3 |
| Wedge Pack Assembly | M8 | 130 | 14.7 |
| Seal Plate to Actuator Plate (Bottom, Torx Drive) | M6 Flat Head | 80 | 9.0 |
| Seal Plate to Actuator Plate (Top, Hex Head) | M6 Hex Head | 50 | 5.6 |
| Arms to Actuator | M10 | 300 (25 ft-lbs) | 33.9 |
| Anodes *No thread locker | M5 | 25 | 2.8 |
| Blades to Arms | M8 | 130 | 14.7 |