{"id":9773,"date":"2022-02-28T13:57:18","date_gmt":"2022-02-28T13:57:18","guid":{"rendered":"https:\/\/manuals.seakeeper.com\/seakeeper-18-operation-manual-90673-1-draft-copy\/maintenance\/scheduled-maintenance-table\/"},"modified":"2023-03-15T16:47:35","modified_gmt":"2023-03-15T16:47:35","slug":"scheduled-maintenance-table","status":"publish","type":"page","link":"https:\/\/manuals.seakeeper.com\/seakeeper\/seakeeper-16-18-operation-manual\/maintenance\/scheduled-maintenance-table\/","title":{"rendered":"Scheduled Maintenance Table"},"content":{"rendered":"\n

The following table contains the scheduled maintenance plan organized by systems: Mechanical, Hydraulic, Cooling, and Electrical. Scheduled maintenance is not covered under warranty.<\/p>\n\n\n\n

For maintenance, find your local dealer at the Seakeeper<\/span> Dealer Locator<\/a>.<\/p>\n\n\n\n

System \/ Component<\/th>Task<\/th>Interval<\/th>Parts \/ Special Tools<\/th><\/tr><\/thead>
Mechanical \/ Corrosion<\/td>Inspect unit for severely corroded areas and clean and touch up with paint. See Service Bulletin 90026 \u2013 Seakeeper<\/span> Paint Information.<\/em><\/td>12 Months or 1000 Hours<\/td>Awlgrip Paint P\/N\u2019s:
Primer: S9001
Primer Converter: S3001
Top Coat, Snow White: F8063
Top Coat Converter: G3010<\/sub><\/td><\/tr>
Hydraulic \/ Hoses<\/td>Check for cracks or chafing. If chafing found, reposition hose to provide clearance around hose. If chafing is severe, replace hose. Charge system per Service Bulletin 90025 \u2013 Brake Bleeding.<\/td>12 Months or 1000 Hours<\/td>Hydraulic Hand Pump Kit<\/td><\/tr>
Mechanical \/ Hydraulic Brake<\/td>Replace brake bushings, hydraulic accumulators and check valves<\/td>Inspect at 12 Months or 1000 Hours \u2013 Replace as needed or at 2000 Hours<\/td>Hydraulic Hand Pump Kit, Brake Bushing Replacement Tool Kit, Hydraulic Brake Parts Kit<\/td><\/tr>
Mechanical \/ Hydraulic Brake<\/td>Flush Hydraulic Oil<\/td>12 Months or 1000 Hours<\/td>Hydraulic Hand Pump Kit Oil: AW46<\/td><\/tr>
Cooling \/ Zinc Anode<\/td>Replace zinc anode as needed. Note the wear rate after each check and adjust inspection interval accordingly.<\/td>3 Months or 150 Hours<\/td>Replacement Zincs are available from Seakeeper<\/span>.<\/td><\/tr>
Cooling \/ Hoses<\/td>Check for cracks or chafing. If damaged, replace hose. Fill cooling system and purge air.<\/td>12 Months or 1000 Hours<\/td>Anti-freeze \u2013 50\/50 Ethylene Glycol mix.<\/td><\/tr>
Cooling \/ Seawater side<\/td>Inspect heat exchanger for signs of leaks.<\/td>3 Months or 150 Hours<\/td><\/td><\/tr>
Cooling \/ Seawater side<\/td>Fill with environmentally safe, marine anti-freeze during winter or periods of in-operation.<\/td>Winter<\/td><\/td><\/tr>
Cooling \/ System<\/td>Cooling system flush<\/td>12 Months or 1000 Hours<\/td>Fill reservoir, antifreeze \u2013 50\/50 Ethylene Glycol mix<\/td><\/tr>
Electrical \/ Connectors<\/td>Inspect all connectors for corrosion, replace if necessary.<\/td>12 Months or 1000 Hours<\/td><\/td><\/tr>
Electrical \/ Grounds<\/td>Inspect all ground points for corrosion, clean as necessary, and treat with corrosion inhibitor.<\/td>12 Months or 1000 Hours<\/td><\/td><\/tr>
Electrical \/ Gimbal Angle Sensor<\/td>Check calibration of sensor. See Service Bulletin 90083 \u2013 Gimbal Angle Sensor Replacement and Calibration, for instructions.<\/td>Only if Angle Alarms occur<\/td><\/td><\/tr>
Electrical \/ Cables<\/td>Check all cables and wire harness branches for cracks or chafing. Take special attention to gimbal shaft areas.<\/td>12 Months or 1000 Hours<\/td><\/td><\/tr>
Electrical \/ Power Input<\/td>Check for seal at cable glands.<\/td>12 Months or 1000 Hours<\/td><\/td><\/tr>
Electrical \/ Motor Power<\/td>Check integrity of motor power cable jacket.<\/td>12 Months or 1000 Hours<\/td><\/td><\/tr>
Electrical \/ Pump Power Output Cable<\/td>Check integrity of cable jacket and inspect connectors.<\/td>12 Months or 1000 Hours <\/td><\/td><\/tr>
Electrical \/ Pump Power Input Cable<\/td>Check integrity of cable jacket and inspect connectors. <\/td>12 Months or 1000 Hours <\/td><\/td><\/tr><\/tbody><\/table><\/figure>\n","protected":false},"excerpt":{"rendered":"

The following table contains the scheduled maintenance plan organized by systems: Mechanical, Hydraulic, Cooling, and Electrical. Scheduled maintenance is not covered under warranty. For maintenance, find your local dealer at the Seakeeper Dealer Locator. System \/ Component Task Interval Parts \/ Special Tools Mechanical \/ Corrosion Inspect unit for severely corroded areas and clean and […]<\/p>\n","protected":false},"author":3,"featured_media":0,"parent":9765,"menu_order":0,"comment_status":"closed","ping_status":"closed","template":"","meta":{"_acf_changed":false,"footnotes":""},"manual":[256],"model":[],"document_type":[],"hidden":[],"class_list":["post-9773","page","type-page","status-publish","hentry","manual-seakeeper-16-18-operation-manual"],"acf":[],"_links":{"self":[{"href":"https:\/\/manuals.seakeeper.com\/seakeeper\/wp-json\/wp\/v2\/pages\/9773","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/manuals.seakeeper.com\/seakeeper\/wp-json\/wp\/v2\/pages"}],"about":[{"href":"https:\/\/manuals.seakeeper.com\/seakeeper\/wp-json\/wp\/v2\/types\/page"}],"author":[{"embeddable":true,"href":"https:\/\/manuals.seakeeper.com\/seakeeper\/wp-json\/wp\/v2\/users\/3"}],"replies":[{"embeddable":true,"href":"https:\/\/manuals.seakeeper.com\/seakeeper\/wp-json\/wp\/v2\/comments?post=9773"}],"version-history":[{"count":4,"href":"https:\/\/manuals.seakeeper.com\/seakeeper\/wp-json\/wp\/v2\/pages\/9773\/revisions"}],"predecessor-version":[{"id":14033,"href":"https:\/\/manuals.seakeeper.com\/seakeeper\/wp-json\/wp\/v2\/pages\/9773\/revisions\/14033"}],"up":[{"embeddable":true,"href":"https:\/\/manuals.seakeeper.com\/seakeeper\/wp-json\/wp\/v2\/pages\/9765"}],"wp:attachment":[{"href":"https:\/\/manuals.seakeeper.com\/seakeeper\/wp-json\/wp\/v2\/media?parent=9773"}],"wp:term":[{"taxonomy":"manual","embeddable":true,"href":"https:\/\/manuals.seakeeper.com\/seakeeper\/wp-json\/wp\/v2\/manual?post=9773"},{"taxonomy":"model","embeddable":true,"href":"https:\/\/manuals.seakeeper.com\/seakeeper\/wp-json\/wp\/v2\/model?post=9773"},{"taxonomy":"document_type","embeddable":true,"href":"https:\/\/manuals.seakeeper.com\/seakeeper\/wp-json\/wp\/v2\/document_type?post=9773"},{"taxonomy":"hidden","embeddable":true,"href":"https:\/\/manuals.seakeeper.com\/seakeeper\/wp-json\/wp\/v2\/hidden?post=9773"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}