9.1 Test Fit the Seal Plate

1. Hang the Wedge Pack on the positioning screws. Align the bottom surface of the Wedge Pack Assembly with the deadrise as indicated in Section 5.
2. When aligned, tighten the positioning screws to hold the Wedge Pack in place.
3. Thread in two (2) of the bottom six (6) M6-1.0 x 16 mm Flathead Screws to align the Seal Plate with the Wedge Pack Assembly, but do not tighten. See figures below.

Figure 52 – Seal Plate Test Fit

5. Thread in two (2) of the top four (4) M6-1.0 x 30 mm Hex Head Bolts with M6 Washers to align the Seal Plate with the Wedge Pack Assembly, but do not tighten. There should be a gap between the top of the Seal Plate and the Wedge Pack Assembly.

6. Using a straight edge, verify that the Seal Plate is in the position identified in Section 5. Due to different hull shapes and features, the Seal Plate may not be flush with the hull bottom across its full span. However, make sure no part of the Controller is below the RRL. For more information, refer to Section 5.
7. If the Seal Plate is not flush in the location needed, repeat Section 7, modifying the number of Wedge Plates until the correct angle has been achieved. Note: When removing and re-inserting bolts, be cautious of debris on the hardware that can cause it to bind, including old thread locker, dirt, etc.
8. Once fit is satisfactory, mark the alignment with a writing utensil on inboard and outboard sides of the Transom Plate to make the final mounting easier.
9. Remove the Seal Plate from the Wedge Pack.