Preparing the Wedge Pack Introduction

This portion of the installation will require the Wedge Pack hardware kit illustrated in Section 4. 

To begin the Transom Plate must be assembled. This requires selecting the correct length bolts as indicated by the transom angle table above. 

1. Place a Cylindrical Washer for Hex Head on each bolt, with the flat side on the head of the bolt. 
2. Install the bottom five (5) M8 bolts must be selected based upon the total Wedge Plates in use. See Table 2 to determine if the 35mm or 40mm bolts must be used. (The Quad controller systems will have three [3] bolts.) 
3. The top four (4) M8 bolts must be selected based upon the total Wedge Plates in use. See Table 3 to determine if the 55 mm or 75 mm bolts must be used. (The Quad controller systems will have two [2] bolts.) 
4. At this point, the bolts must be inserted into the Transom Plate with Cylindrical Washer for Hex Head cylinder in each of the 9 locations. (The Quad controller systems will have five [5] locations.)
5. Cover the bolt head with the supplied self adhesive backed plastic caps. The caps will prevent adhesive leak by around the bolts and allow for tuning the equipment by adding or removing wedges once installed and adhesive has cured.