1. Introduction

Updated on: 05/29/25

This document is intended to give details and guidance to a boat builder or equipment installer on the proper procedure for the electrical installation of a Seakeeper Ride system.

Because of the quantity of parts and careful installation requirements, set aside a clean, well-ventilated workspace, take inventory of necessary tools and parts, and review the entirety of this manual before setting to work.

Note: Scan the QR code below to access Seakeeper Ride BILT 3D instructions.

Seakeeper Ride Supplied

  1. Software Module
  2. Distribution Module
  3. Controllers
  4. Keypad (Optional)

Boat/Customer Supplied

  1. NMEA 2000 Backbone
  2. Multifunction Display (MFD)
  3. 12 V or 24 V Positive, Negative, and Ground Terminals
  4. 15 Amp Circuit Breaker or Fuse (25 Amp for Four Controller Systems)
  5. Battery Isolation Switch
Two Controller Electrical Overview
Four Controller Electrical Overview