4. Inventory Parts

Please review all parts included before proceeding. The following figure and table describe all parts included in the assembly. Review parts and ensure all parts are present before starting the installation procedure.

Components shown are per Controller. Dual Actuator systems will have two (2) times the components listed, and Quad Actuator systems will have four (4) times the components listed.

---

Hardware counts below are given in the format: x[375 CONTROLLER] | [525 CONTROLLER] | [750 CONTROLLER] 

Wedge Pack Hardware				Positioning Screws
x3 | 4 | 5 M8-1.25 X 35 mm Hex Head Bolt	x3 | 4 | 5 M8-1.25 X 40 mm Hex Head Bolt	x2 | 2 | 4 M8-1.25 X 55 mm Hex Head Bolt	x2 | 2 | 4 M8-1.25 X 75 mm Hex Head Bolt	x3 Phillips No. 8 x 1.25 in. Screw
x5 | 6 | 9 M8 Cylindrical Washer for Hex Head	x5 | 6 | 9 Transom Plate Bolt Cover	x5 | 6 | 9 M8 Cylindrical Washer	x5 | 6 | 9 M8 Wedge lock Washer	x5 | 6 | 9 M8-1.25 Hex Nut
Seal Plate Hardware			Blade Hardware
x4 | 4 | 6 M6-1.0 x 30 mm Hex Head Bolt	x4 | 4 | 6 M6 Washer	x6 | 9 | 10 M6-1.0 x 16 mm Flathead Screw	x4 M8-1.25 X 30 mm Hex Head Bolt	x4 M8 Washer
Cable Routing Hardware			Endcaps
x2 Phillips No. 8 x 0.75 in. Screw	x2 Phillips No. 8 x 1.5 in. Screw	x2 Phillips No. 10 x 1.0 in. Screw	x0 | 0 | 2 Endcaps (Only included with 750 Controller systems)