2.3. The Navigation Bar

The Home and Setting buttons are used to navigate between pages.

Home

On the Seakeeper Ride Home page, the operator will be presented with the directional arrows, the Auto/Manual button and graphic indicators based on the mode selected. Refer to the previous sections for more details on the Home Screen.

Settings

The Settings page allows for adjustment to the System, GPS, and Trim Command Curve (TCC). The selection of each of the screens are in the top right-hand corner of the screen once on the Settings page.

Info

The Info sub menu allows the operator view details to their Ride System.

System

The System page allows the operator the ability to adjust position of the Home and Menu buttons from top right (default) to top left of the page.

Adapt Settings allows the operator to adjust the system for RF Disable (Autopilot) Instructions.

The Keypad Settings allow the operator to adjust Keypad backlight for day (bright) or night (dim) display and the Brightness allows for finite changes to the backlight. When on this screen the operator can select the + button to increase the brightness and the – sign to decrease the brightness. The percentages chosen are different for Day and Night. Once both day and night have been set and they are clear and visible, select the Home button to return to the home screen.

Note: The pages below are examples and may not match information details of the installed Seakeeper Ride system.

GPS

The GPS page displays the selected GPS Source. By Default Ride will select the source available on the NMEA2000 Bus with the lowest EPE and HDOP. This page allows the operator to manually override the GPS source selection if desired. The GPS source will show the GPS manufacturer currently selected and other live data GPS statuses.

Note: The pages below are examples and may not match information details of the installed Seakeeper Ride system.

Trim Command Curve

The Trim Command Curve (TCC) is covered in detail in Section 3.3. Please read the full Operation Manual carefully before making changes to the Trim Command Curve.

Note: The pages below are examples and may not match information details of the installed Seakeeper Ride system.

Info

The Info page provides details about Seakeeper Ride components, sizes, serial numbers, software versions, and other information. This information will be useful for warranty registration, software updates and troubleshooting.

Note: The Info page below is an example and may not match information details of the installed Seakeeper Ride system.

Serial Numbers

When referencing serial numbers, the Software Module serial number is equivalent to the system serial number. To locate the Controller serial numbers, select the Controllers tab on the menu. Information on the Port 1 Controller will show, including serial number. Press the arrows to navigate between all the controllers of the Ride system.

Fault History

The Faults page shows what faults and warnings that are Active and Historic Faults that have occurred in the past and their associated run hours.

Note: Faults can be cleared using the service page.

Info

Within the Info Screen are pages for

Service

Faults